6 Inch Lift Bilstein lift kits for Silverado, GMC Sierra, Denali

Silverado, GMC Sierra, Denali 1500 trucks offers one of the most significant innovations in the industry’s history and Pro Comp is right there with them. The one-piece drop down crossmembers and high-strength, extended steering knuckles install easily and maintain ideal steering geometry and factory CV axle angles.They are compatible with the factory stability control system and can fit 35-inch tires.

6 inch Lift Bilstein Lift Kit Features:

• Fits for Silverado, GMC Sierra, Denali
• Front strut spacer
• Extended steering knuckle
• High clearance one-piece crossmembers
• Integrated front differential skid plate
• Retains factory ball joints
• Rear blocks with bump stop pad
• Compatible with roll stability control

Please contact us to find out about more information that applies to this product.

Follow on Facebook: 

NOTICE OF DISCLAIMER–Lift and Levelling Kits

Not all lift kits are legal to install on your vehicle. It is the customers’ responsibility to check regulations pertaining to their vehicle and warranty coverage, prior to purchasing and the installation of all lift and levelling kits.

Lift and levelling kits may interfere with vehicle functions including but not limited to stability control, auto levelling functions and chassis clearance issues.

The bigger the lift or levelling kit that is fitted increases the chances of the factory CV joints and ball joints wearing out prematurely. High articulation CV joints are available to minimize this issue if required.

In certain circumstances the factory inner CV joint boots may slip off the end of the shaft due to the change in the angle after a front lift has been fitted. In most circumstances fitting an improved CV boot clamp to the CV boot will assist with this matter.

Ball joints on the upper control arms need to be lubricated after installation and re-greased at each service interval. Without adequate grease they will wear out prematurely and will need to be replaced. It is the customers responsibility to ensure that the ball joints are always kept greased.

It is paramount that all lift kit components that have been installed, be re-torqued after the first 100 kms to adjust for any settling of the suspension components; then rechecked at each service interval to ensure that everything is correctly torqued. This is the customers responsibility as loose components can cause damage to your vehicle.

It is suggested that the customer does their own research prior to purchasing and requesting the installation of lift and levelling kits to their vehicle.